The mechanical springs are usually mounted in the cavity of the clockwork wheel. There is a cover on the wheel surface. You only need to press the center shaft down to press the cover. Be careful when handling, the spring is easy to pop out, and if you don’t pay attention, the center shaft will be bounced. If you are not sure, find the best master.
Winding method on the mechanical watch: Rotate the crown 20-30 times to make the spring initial. A full spring can usually make the watch walk for more than 30 hours, up to eight days or more. If you want to keep working, you need to pay attention to tightening the spring at any time. However, excessive tightening of the spring will cause the watch to be damaged. Therefore, it is usually recommended to fill the clock once a day. Some people even suggest that you should send it at the same time every day. The reason is that the temperature at different times will have an effect on the spring, which will better maintain the watch.
Watch clock removal steps
1. Open the back cover.
2. There is a pit next to the shaft.
3. Use a needle tip to press the pit.
4. Pull out the watch at the same time.
5, in fact, is a “lock” stuck in the watch, and finally pull the axis of the starting bar.
How much does the watch’s clockwork break? Watch clock broke the repair price
How much is the watch’s clockwork broken?
The watch is broken because it is due to the following two reasons:
1. The watch disengages the spring. It means that you rotate the crown. There is a gear on the crown to drive the tensioning gear on the barrel. The gear is broken. Now the gear is broken when you turn, and the teeth are slippery. Sound, so I can’t get on it.
2, the spring is broken, this is also a relatively common problem, the spring broke in the box, causing the broken spring when you are energetic, the idling is also idling.
No matter what kind of problem, you need professional repairs, you can’t fix it. As for the price, it depends on the original price of your watch. If it is Tissot, the first problem is 200, the second is 500. If it is Rolex, the first problem is 500, and the second is in 5000.
How to repair the watch
After the watch spring is broken near the outer hook, the outer hook can be re-made with the waste spring. The method for making the sheet-shaped outer hook is to select a scrap spring with a higher hardness and strength than the spring and to break it as a material for repairing the outer hook material of the spring, and then the triangular pyramid drill made by the small round tamper has been repelled. The outer end of the spring or the end of the outer hook is drilled with a small hole, and the outer hook is twisted or ground into a diagonal mouth, and they are riveted and fixed, and the riveted convex part should be removed. The outer hook of the spring and the fixing of the spring are currently more than its circuit schematic. The welding procedure and method are as follows: After the power is turned on, the final spring is clamped to the end of the long welding head, and the closing switch indicator light is illuminated to repair the failure of the spring.